Testing: Difference between revisions

From Collins 30S-1 HF Amplifier
Jump to navigation Jump to search
(Created page with "=120V Initial Testing=")
 
Line 1: Line 1:
=120V Initial Testing=
=120V Initial Testing=
<ul>
<li>I installed the original 4CX1000A tube which came in my amplifier. Only the 3.2A fuse was installed, and I applied power!</li>
<li>The meters illuminated; after the time-delay relay closed, the dials also illuminated. The "ON / OFF" switch functioned.</li>
<li>Opening either the top-lid or the front-panel removed the dial-illumination, and prevented operation of the "ON / OFF" switch.</li>
<li>I tested the Thermal Overload switch K102 by moving it out of, and back into the airstream - it works, and disables the "ON / OFF" switch when there is no airflow over the sensor.</li>
</ul>
<p>The Safety and Control seem to work. The Bias and Filament adjustments work.</p>

Revision as of 21:34, 29 June 2021

120V Initial Testing

  • I installed the original 4CX1000A tube which came in my amplifier. Only the 3.2A fuse was installed, and I applied power!
  • The meters illuminated; after the time-delay relay closed, the dials also illuminated. The "ON / OFF" switch functioned.
  • Opening either the top-lid or the front-panel removed the dial-illumination, and prevented operation of the "ON / OFF" switch.
  • I tested the Thermal Overload switch K102 by moving it out of, and back into the airstream - it works, and disables the "ON / OFF" switch when there is no airflow over the sensor.

The Safety and Control seem to work. The Bias and Filament adjustments work.