160m Mods

160m Mods. The 160m mods involve working on: 1. the input PI section, 2. the PA output PI section. 3. changing one of the bandswitch stops.

It's a tight fit inside the input circuit compartment. Facing the front, the 160m variable coil is mounted on the left side next to the 80m coil. The fixed coil and SM caps are tucked inside the semi closed aluminum box.

NB. It appears there are two different 30S1 input circuits depending on the age of the 30S-1 amp. The 160m mod is practical only for input circuits using simple wafers with contacts on one side only. If there is a grounding ring in addition to a selector ring then things get rather complicated. This mod does not deal with the double sided grounding wafers for obvious complex fabrication reasons. The wafers used in the 30S-1 are 45 degree type, next to impossible to find. The bakelite material is old and very easy to fracture. Utmost care is necessary to prevent breakage. The alternative is to make new blanks with FR40 board material a time consuming proposition.

Collins uses 1KV ceramic disk capacitors for the other bands, ideally the 160m capacitors should be 1 KV SM but space is tight. The 500V SMs i showed no leakage up to 1.5KV, and should should be ok up to 100W 3-1 SWR. Alpha 77Sx uses compression silver micas, which have higher Q than ceramics.

Fig.1 160m input-Pi circuit and L, C elements

extra text here

Fig.2 160m input-switch-wafer modifications

extra text here

Fig.3 160m tabs added to input-switch-wafer

extra text here

Fig.4 VNA showing S11 for 160m input-circuit Zload=50 Ohms

extra text here

Fig.5 Schematic showing 160m additions to the PA

extra text here

Fig.6 Clearing a path to the rear PA band wafer for removal

extra text here

• PA-Wafer. Adding 80m and 160m tabs
• 
• 

extra text here

Fig.7 ordinary wafer used for 160m PA vacuum relay switching

extra text here

Fig.8 160m 160m PA vacuum relay

Jennings F4B-26S is a 26V DC latching relay with two 7 Ohms coils. It requires a 26V DC pulse to switch from ON to OFF and viceversa. A pair of 555 timers could be set up, but they require additional power sources. Still investigating a simple relay circuit that converts an ON, OFF state to a pulsed one.

Fig.9 One band switch stop gets drilled out

One of the two band stops is drilled out to yield a 160m position. That's the hole closer to the center shaft. With the RF deck mounted on the PS cabinet, the stop to be drilled out is at ~11:30 o'clock. The other stop at ~6:30 is left alone. In this image the RF deck is laying on its left side. The 30S-1 band knob will point downwards for 160m.